mperez

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 21, 2021 at 3:26 pm in reply to: Can’t save Citrix config using WMS 3.1.559 #105430
    mperez
    Participant
    • Total Post: 4
    • Newbie
    • ★

    I was able to figure this out. The policy I was trying to change was already set in the default policy. I removed what I needed to remove from the default policy and edit the new group I was trying to create.

    October 17, 2019 at 7:33 pm in reply to: WMS: Configuration issue #51009
    mperez
    Participant
    • Total Post: 4
    • Newbie
    • ★

    I was able to get this fixed. I found the solution here in this forum about a windows update that broke NLA  in Wyse ThinOS that was fixed in version 8.6_027. All of my thin clients were running 8.4. At the time of deployment we had some legacy thin clients in our system that required using a direct RDP connection and the DefaultTSVUrl for load balancing.  We replaced all of those with 3040’s, but we did not update our firmware. So long story short, I removed the DefaultTSVUrl, upgraded firmware on both our 3020’s and 3040’s and adjusted my CAP and RAP policies and got it working in my test environment.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)