Wyse Simple Imager assistance needed

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 15, 2007 at 10:06 am #341
    Raspy32
    Member
    • Total Post: 14
    • Regular Joe
    • ★★

    Hi all, I hope someone has had this issue before and can help (and if I missed a post already describing a fix I apologise but I did search).

    I have installed WSI 1.1.4 on a standalone PC running WinXP SP1 along with DHCP Turbo. The FTP is setup (root c:inetpubftproot) with read/write access, the Rapport/Tools/Sa folder created as per the instructions. I added the image within WSI from the existing i2d file but when I restart the v90 terminal it refuses to image.

    It begins the file transfers but almost immediately returns an error “Peer returns ERROR and the terminal sits on waiting for a file Tools/sa/alone/646c9ca8.i2c

    I have double-checked the permissions on the FTP, the static IP (10.1.1.12), but it still refuses to pick up the image. If anyone can suggest anything that may fix the problem I would appreciate it.

    March 17, 2007 at 1:56 pm #9275
    drudrewdizzy
    Member
    • Total Post: 19
    • Regular Joe
    • ★★

    A couple of items to check:

    -Be sure to static the IP, install DHCP and define scope, and then install WSI all while the cross-over cable is attached to a thin client w/ an active NIC? This is important for binding the NIC to the IP address and so on.
    -It’s always best to uninstall WSI and try again, this usually resolves any connectivity issues.
    -Make sure all firewall services are disabled and DEP (if applicable) is only set to protect Windows system files.

    Check out solution 13160 – http://www.wyse.com/serviceandsupport/support/kbase.asp

    March 20, 2007 at 9:42 am #9298
    Raspy32
    Member
    • Total Post: 14
    • Regular Joe
    • ★★

    I checked all of that but had no luck still, however I sorted the problem by imaging from a USB stick instead.

    Thanks for the response though.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.