re-image v90L XPe

  • This topic is empty.
Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • December 17, 2008 at 2:53 am #1654
    bm_5789
    Member
    • Total Post: 7
    • Newbie
    • ★

    I have tried on several ocassions to upgrade the image on a V90L. I’m trying to use the WSI on a laptop with a router in between the laptop and the v90L. I get the PXE-T04 and PXE-E36 errors all the time and the frustration has set in.

    If anyone in the forum has any help/advice to offer to remedy the errors I would be appreciative.

    However, if there is no solution to the errors, I will try the usb image creator.

    I would appreciate any advice anyone has for that method.

    TIA

    December 17, 2008 at 7:10 am #14687
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    Have you installed WSI while your laptop was connected to some network?
    It will not work otherwise.

    CG

    December 17, 2008 at 12:57 pm #14694
    bm_5789
    Member
    • Total Post: 7
    • Newbie
    • ★

    Thanks for your response. Yes, the laptop was connected to the router as was the wyse(not powered on). I downloaded the wyse 1.3.6 admin guide and followed it to the letter.

    December 17, 2008 at 1:14 pm #14695
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    Can you try to connect the client and the laptop via cross-over or a simple hub?

    CG

    December 17, 2008 at 3:35 pm #14696
    bm_5789
    Member
    • Total Post: 7
    • Newbie
    • ★

    Thanks again for your help…I have tried with a router, cross-cable, dumb hub…all with the same results.

    December 17, 2008 at 10:17 pm #14700
    bm_5789
    Member
    • Total Post: 7
    • Newbie
    • ★

    Update!!!!

    I was able to use the usb flash to upgrade the v90L. All is well. Thanks to everyone who offered help.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.