CivMason

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • October 1, 2007 at 6:23 pm in reply to: Mixed 1200LE and S10 environment DHCP config issue #10330
    CivMason
    Member
    • Total Post: 2
    • Newbie
    • ★

    Thanks for replying so quickly!

    I did not in fact configure that setting as a string. I just went back and reconfigured the value to be a string value, then tested and I’m still getting the same result. Any other ideas on what I might have done wrong? I’m a complete newb to the Thin O/S clients in particular, and not terribly versed with Wyse terminals in general. Are there any documents out there for the configuration of these settings? I found one document as I was looking up wnos.ini syntax that mentioned setting up a new vendor class to put the 161 and 162 values in, which I did, but the article was a little vague. Anything better out there?

    Thanks again, ConfGen and all, for the assistance!

  • Author
    Posts
Viewing 1 post (of 1 total)