nbg

Forum Replies Created

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • December 7, 2022 at 7:24 am in reply to: ctrl+alt+f4 keyboard shortcut not working ThinOS 2208 #107966
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    Thanks for the feedback Bumblebee.

    February 9, 2021 at 11:27 am in reply to: Firmware check delay #71999
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    It turned out that the delay was caused by a certificate not being installed properly. I ended up creating a new collection and made sure only to include the necessary certificates and now the wyse devices boots up in a few seconds.

    January 25, 2019 at 1:26 pm in reply to: RDP icons on desktop #48939
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    Ok, it works now. Thank you.

    January 25, 2019 at 11:27 am in reply to: RDP icons on desktop #48937
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    Yes I added them like this:

    January 25, 2019 at 10:46 am in reply to: RDP icons on desktop #48935
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    Apparently it is only possible to add a single rdp connection this way. When I add two rdp connections in the advanced section only one icon show up on the desktop. I can also only see one connection in the connection manager.

    January 25, 2019 at 9:43 am in reply to: RDP icons on desktop #48933
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    I must admit that I feel a little stupid not realising that I have to add the whole RDP connection string to the advanced section. Thanks it works now 🙂

    Do you know if the icon parameter is being added to the direct RDP connections section in WMS in the future? I would quickly run out of lines in the advanced section if I were to add multiple RDP connections.

    June 27, 2017 at 1:19 pm in reply to: DVD drive redirection TCX #44681
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    Yes I have allowed mass storage devices in the Wyse TCX suite. I tested it with a NTFS formatted USB flash drive and it was redirected with TCX without problems.

    March 18, 2016 at 1:27 pm in reply to: RDP usb redirection #42602
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    It works now, thanks

    March 18, 2016 at 7:02 am in reply to: RDP usb redirection #42600
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    The SD cards are using exFAT filesystem.

    March 17, 2016 at 8:09 am in reply to: RDP usb redirection #42598
    nbg
    Participant
    • Total Post: 17
    • Regular Joe
    • ★★

    It says “USB: Found a new 480Mbps device “Mass Storage” on port 7″. I noticed that when i plug in a usb flash drive it also says “D: registered, 0xb, size 7681 MB”. It doesn’t say that when I plug in the sd card reader.

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)