AlfredWebb4

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 1, 2019 at 8:56 pm in reply to: Wyse 5070 with 3 + monitors – sample config #51312
    AlfredWebb4
    Participant
    • Total Post: 3
    • Newbie
    • ★

    added the following line to the display config (after your example above) so that the displays were not in “mirror” mode:

    Screen=1 Resolution=DDC Align=1,bottom,center
    Screen=2 Resolution=DDC Aligh=2,bottom,left
    Screen=3 Resolution=DDC Align=3,bottom,right

    Dualhead=yes Mainscreen=1

    Screen still not aligning as expected. I assumed “screen 1” was the display port closest to the USB ports based on the marking on the unit (and numbered sequentially after that). However, on my test bench using 2 VGA based  and 1 DVI based display port adapters, screen 1 is the DVI monitor regardless of the display port it is plugged in to.

    Is there some logic I am missing here? Is there a monitor interface precedence?

    November 25, 2019 at 11:16 pm in reply to: Wyse 5070 with 3 + monitors – sample config #51290
    AlfredWebb4
    Participant
    • Total Post: 3
    • Newbie
    • ★

    Still need some help with syntax. I get three independent monitors but they are not following my “alignment”. This is the display portion of my config:

    Screen=1 Resolution=DDC
    Screen=2 Resolution=DDC
    Screen=3 Resolution=DDC
    Align=screen 1, bottom,center
    Aligh=screen 2, bottom,left
    Align=screen 3, bottom,right

    Please note I am leaving a space between screen and the screen number (if that is a syntax error) and no spaces (just a comma) between the positional parameters.

    Also, should the align syntax be one long line.

    Unfortunately I still have no three monitor configs found via web search to use as an example.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)