WMS and Wyses 5070 config issue

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • November 5, 2020 at 7:27 pm #53448
    aidechoute
    Participant
    • Total Post: 13
    • Regular Joe
    • ★★

    Hello,

    I have an issue with some wyses 5070 and WMS.

    I just want to create a rules that modify the VNC password on my Wyses 5070.

    My wyses is already setup manually with some RDP icons with specific settings (user autoconnect, screen resolution and position etc…), wallpaper etc…

    Everything is working fine.

    When I put the Wyse into wms, the new vnc password is well push but i also lost all of my config that i have previously set.

    If I turn off the write protection and reboot the Wyse everything is working fine.

    I don’t understand why it’s acting like this, If someone have an idea it could be great 😀

    Thanks

    November 6, 2020 at 5:00 pm #53470
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    Either you configure the unit locally or with WMS.
    When WMS kicks in it removes local settings to get a unique look&fell on all units.

    CG

    November 6, 2020 at 5:13 pm #53471
    aidechoute
    Participant
    • Total Post: 13
    • Regular Joe
    • ★★

    Hello,

    So if i just want to change the VNC password i can’t do it with WMS without modify all my “local” settings??

    And why when I’m in “writable”mode i have my local settings?

    Thank for your help

    November 7, 2020 at 3:59 pm #53472
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    Yes, correct.

    And why when I’m in “writable”mode i have my local settings?

    Please clarify

    CG

    November 9, 2020 at 9:27 am #53476
    aidechoute
    Participant
    • Total Post: 13
    • Regular Joe
    • ★★

    Thanks for your answer regarding the writable mode here is my explanation:

    I prepare my Wyse 5070 with the wallpaper and the specific RDP on each wyses (resolution /screen / user / winposstr etc…)

    I block this config with the “WF Active”, I try all the config on the user session without joining WMS and it’s ok.

    Then I join to WMS, and all the config are lost.

    Once i have join the WMS if I disable the “WF” on the Wyse and i reboot it my config is back as I have configure before.

    Is it clear?

    November 11, 2020 at 1:06 pm #53493
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    I would say, works as designed.
    When using WMS only WMS settings are used.

    CG

    November 13, 2020 at 2:29 pm #53505
    aidechoute
    Participant
    • Total Post: 13
    • Regular Joe
    • ★★

    Hello,

    I think that i understand what is going wrong

    I will make a test on 20th of november when the factory is stop and i will let you know  if i found something

    Thanks for you help!!

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.