Reply To: Expend 512 MB XPe image on 1GB Flash

#14577
enam
Member
  • Total Post: 144
  • Legend in Own LunchBox
  • ★★★★★

Hi CG,

Below is step by step commands which I used to extend the partition.

Extend command works fine but only extend the volume not file system… shown in picture below.

Microsoft DiskPart version 5.1.3565.1

DISKPART> select disk 0
Disk 0 is now the selected disk.

DISKPART> select partition 2
Partition 2 is now the selected partition.

DISKPART> extend size = 966
DiskPart failed to extend the volume.
Please make sure the volume is valid for extending.

(Comment : extend size = 966, or extend size = 974 does not work, only extend command works.)

DISKPART> extend
DiskPart Successfully extended the volume but failed to extend the file system.
To retry this operation use the DiskPart Command EXTEND FILESYSTEM.

DISKPART> extend FILESYSTEM
DiskPart failed to extend the file system on the volume.

DISKPART> create partition primary
DiskPart was unable to create the specified partition.

Any idea what I am doing wrong.

Regards,
Enam